Panasonic KX-NS300, Pc Programming Manual

Page: 262 / 752

9.23 PBX Configuration—[1-1] Configuration—Slot
—Card Property - LCO type
The properties of the analogue trunk cards can be specified.
Name Description Value Range Links
Outgoing Guard
Time Specifies the length of time after a
trunk is disconnected, during which
the PBX cannot seize the line. 3–6 s
First Dial Timer (CO) Specifies the minimum time that the
PBX waits after seizing a trunk,
before sending the dialled digits to
the telephone company. This allows
the telephone company to have
enough time to accept the dialled
digits correctly. 0.5 × n (n=1–
16) s
CO Feed Back Tone Specifies whether the pulse
feedback tone is turned on or not.
For outgoing trunk calls, audible
tones can be heard as the dialled
number is sent out, which informs
the extension user that the number
has been dialled. No, Yes
Bell Detection—Bell
Start Detection Timer Specifies the minimum length of a
bell signal that can be recognised by
the PBX as the bell signal sent from
the telephone company, before the
PBX detects an arriving call. 24 × n (n=1–
50) ms
Bell Detection—Bell
Off Detection Timer Specifies the duration of the bell off
detection timer. If the PBX receives
no bell signal from the telephone
company for the length of time
specified here, the PBX treats the
call as lost. 1.0 s–15.0 s
Pulse / DTMF Dial—
DTMF Inter-digit
Pause Specifies the length of the DTMF
inter-digit pause. This allows the
telephone company to have enough
time to accept the dialled digits
correctly. 64 + 16 × n
(n=0–11) ms
Pulse / DTMF Dial—
Pulse Inter-digit
Pause Specifies the length of the pulse
inter-digit pause. This allows the
telephone company to have enough
time to accept the dialled digits
correctly. 630 ms, 830
ms, 1030 ms
9.23 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
262 PC Programming Manual