Panasonic KX-NS1000, Pc Programming Manual

Page: 56 / 1294

A •
It is not possible to use the same number for 2 items.
The number you are trying to store cannot be used if it is already being used by:
•
A feature number
•
An extension
•
A Dial setting (see 17.1 PBX Configuration—[9-1] Private Network—TIE
Table )
•
Quick Dialing (see 10.6.2 PBX Configuration—[2-6-2] System—Numbering
Plan—Quick Dial )
In any of these cases, choose another number.
Q I cannot change a feature number on the B/NA DND Call Feature screen.
A •
The number you are trying to store is already being used by another call feature.
Please choose a different number.
Q How do I prevent extension numbers being automatically assigned to a newly
installed card?
A •
Change New Card Installation—Automatic Extension Number Set for
Extension Card in the 9.31 PBX Configuration—[1-3] Configuration—Option
screen from "Enable" to "Disable".
Saving Modified Data
Q Modified settings have not been updated in the PBX.
A •
Click Apply or OK in the main screen.
Q If I reset the PBX directly after modifying settings, the modified settings are not
updated in the PBX.
A •
When you click Apply , the settings are updated in the PBX, but are not yet saved to
the Storage Memory Card. If system data is not saved to the Storage Memory Card,
the PBX will restore the data that was last saved to the card in the event that the PBX
is reset, or power is turned off and back on again.
Therefore, before resetting the PBX, click the button on the Home screen to save
the system data to the Storage Memory Card. Also, when you finish a programming
session, be sure to click the
button to logout and save the system data to the
Storage Memory Card.
Note
Do not remove the Storage Memory Card while power is supplied to the PBX.
Doing so may cause the PBX to fail to start when you try to restart the system.
Q After reinitializing the PBX, I restored system data from a previous backup.
However, some of the settings have not been restored to their previous values.
56 PC Programming Manual Document Version 2016-03
2.3 Frequently Asked Questions (FAQ)