Panasonic KX-NS1000, Pc Programming Manual

Page: 205 / 1294

To remove a card from the PBX
1.
Move the mouse pointer over the card to remove.
A menu will be shown under the mouse pointer.
2.
Select Delete .
3.
Click OK to confirm.
The card will be removed.
Note
When deleting a physical combination card, both cards must be set to OUS before selecting Delete .
To change the status (INS/OUS) of a card (On-line mode only)
1.
Move the mouse pointer over the card. For combination physical cards, move the mouse pointer over the
individual card name.
A menu will be shown under the mouse pointer.
2.
Select the desired status:
•
Click INS to set the card to in-service status.
•
Click OUS to set the card to out-of-service status.
To access IP-PT port properties
1.
When you place the mouse cursor over the IP Phone Registration button on the Slot screen, the following
choices appear. Click an option to open a port properties programming screen:
IP-PT : For KX-NT300/KX-NT500 series and KX-NT265 (software version 2.00 or later) IP-PTs
(
®
9.15 PBX Configuration—[1-1] Configuration—Slot—V-IPEXT32—Port Property )
SIP-MLT : For KX-UT series SIP phones
(
®
9.21 PBX Configuration—[1-1] Configuration—Slot—V-UTEXT32—Port Property )
Standard SIP Phone : For third party SIP Phones
(
®
9.17 PBX Configuration—[1-1] Configuration—Slot—V-SIPEXT32—Port Property )
Option : Opens the Site Property—Main screen.
(
®
9.5.1 PBX Configuration—[1-1] Configuration—Slot—Site Property—Main )
To pre-install PBXs connected to the STACK-M card
Before programming a legacy gateway, it must be pre-installed to enable the Legacy-GW1 and
Legacy-GW2 shelf buttons.
1.
Install the STACK-M card and connect the legacy gateway PBX to the STACK-M card using the supplied
stacking cable. For details, refer to
4.6 Stacking Cards in the KX-NS1000 Installation Manual.
2.
In the Configuration—Slot physical shelf screen, click on the STACK-M card in the list on the right.
3.
Click and drag the image of the STACK-M card to the slot, and release it. The card will move into the slot
space.
4.
Click OK to confirm.
5.
Place the mouse cursor over the STACK-M card, and in the menu that appears, click Pre-Install .
6.
In Cabinet Type , select the model of the PBX connected to connection port 1 of the STACK-M card, and
then click the arrow button.
7.
If a second legacy gateway PBX is connected to connection port 2 of the STACK-M card, select the model
of the PBX connected to connection port 2, and then click the arrow button.
Document Version 2016-03 PC Programming Manual 205
9.1 PBX Configuration—[1-1] Configuration—Slot