Panasonic KX-NS1000, Pc Programming Manual

Page: 110 / 1294

6.13 Tool—UT Option Setting
Option settings can be specified for KX-UT series SIP phones on a system-wide level.
Note
The following apply when programming in On-line mode only:
•
To apply changes made to these settings for KX-UT series SIP phones connected to Slave unit PBXs
in a One-look network, be sure to click the icon after programming. Otherwise, there may be a delay
of 30 minutes or more before changed settings are applied.
•
To set these parameters, all installed V-UTEXT32 cards must first be set to OUS. For details, see
9.1 PBX Configuration—[1-1] Configuration—Slot .
Numbering Plan for UT Series Terminal
One or more number dialing plans can be specified for KX-UT series SIP phones. Enter the dial plan text string
into the text box, and then click
OK . A dial plan text string may also be copied and pasted into the text box
from another source.
Note
•
For more information about dial plans, refer to the Administrator Guide of the relevant KX-UT series
SIP phone.
•
You can enter up to 500 characters in the dial plan text box.
•
You can assign up to 20 dial plans, separating them with a "|" (vertical bar).
•
You can assign up to 32 digits per dial plan.
•
When OK is clicked, the entered text string will be validated. If there is a validation error, a message
will be displayed.
•
The default value of the Dial plan depends on the Numbering Plan selected when the Easy Setup
Wizard was run to configure the PBX. For details, refer to 5.4.1 Easy Setup Wizard in the Installation
Manual.
•
When a 3-digit numbering plan is selected: [1-6]XX|[1-9]11|9[1-9]11
•
When a 4-digit numbering plan is selected: [1-2]XXX|5XXX|6XXX|[1-9]11|9[1-9]11
Timer for UT Series Terminal
This timer specifies for KX-UT series SIP phones how long the system waits for another digit to be dialed before
determining that dialing has finished. This value will apply for all KX-UT series SIP phones connected to the
PBX. Specify a number of seconds in
Extension Inter-digit (s) , and then click OK .
If the value for the timer is changed, the new value will be applied to each KX-UT series SIP phone after it is
restarted.
110 PC Programming Manual Document Version 2016-03
6.13 Tool—UT Option Setting