Panasonic KX-MB1520FX7, Service Manual

Page: 87 / 396

87
KX-MB1520FX7/KX-MB1520FX8/KX-MB1520FXW/KX-MB1530FX7/KX-MB1530FXW
8.1.2.2. Manual input tray
You can use the manual input tray for printing with the computer and for copying. It can hold one page at a time.
When printing or copying multiple pages, add the next page after the first page has been fed into the unit.
• When printing with the computer, custom size recording paper can also be used.
• The unit is set for printing A4-size plain paper by default.
- To use other paper sizes, change the recording paper size setting (feature #381). (Refer to Program Mode Table (P.117).)
- To use thin or thick paper, change the recording paper type setting (feature #384). (Refer to Program Mode Table (P.117).)
When printing on thick paper
8.1.3. Documents the Unit Can Send
Note:
• Confirm that there are no documents in the automatic document feeder (KX-MB1530 only).
• Place the original onto the scanner glass gently. To avoid malfunction, do not press down too firmly.
• If the original is a book thicker than 15 mm, do not close the document cover.
• Confirm that any ink, paste or correction fluid has dried completely.
• Effective scanning area is shown by the shaded area:
Effective scanning area
1.
Adjust the width of the guides (1) to the size of the recording paper.
2. Insert the paper, print-side up (2) until the unit grasps the paper and a
single beep is heard.
Note:
• To print from the manual input tray;
- when printing with the computer, select #2 for the printer proper-
ties.
- when making a copy, set the copy input tray setting to “#2” before-
hand (feature #460). (Refer to Program Mode Table (P.117).)
If these settings are not changed, when printing or
copying multiple pages, the 1st page will be printed
from the manual input tray, but the rest of the pages
will be printed from the paper input tray.
• If the paper is not inserted correctly, re-adjust the paper, or the
paper may jam.
• When you use thick paper for the recording paper, be sure to open
the rear cover before start printing. Thick paper will be printed out at
the back of the machine. Therefore, if you print with the cover
closed, the paper will jam inside the unit.