Conditions
Note
When the transfer destination is an extension:
If the transfer destination does not answer within the pre-
programmed time period (
FWD No Answer Time
), either FWD NA
or Transfer Recall will operate.
When the transfer destination is a trunk:
If the transfer destination does not answer within 180 seconds,
Transfer Recall will operate.
Refer to 3.1.9 Call Forwarding
(FWD)
It is possible to select the operation when the call is transferred to
extension or extension group as follows:
•
FWD Priority
FWD NA will operate when FWD NA is set. Otherwise Transfer
Recall will operate.
•
Transfer Recall
Transfer Recall will always operate.
Programming Item List:
•
2.3.2 PBX Configuration—[2-2]
Extension—Phone—
FWD/DND—Transferred call
no answer option
•
2.3.4 PBX Configuration—[2-4]
Extension—Extension Group—
Group Setting—Transferred
call no answer option
Transfer Recall operation is different depending on the status of the
forwarding extension:
•
Idle
Transfer Recall will operate.
•
During a conversation or receiving a call
If Call Waiting is enabled, Transfer Recall will operate. Otherwise,
Transfer Recall will operate as soon as the forwarding extension
goes becomes idle.
If there is no answer to the
second call from the transfer
destination after calling for a
preprogrammed time period
(
Disconnect after Recall
(x60s)
), it will be disconnected.
PIL Reference
2.2.5 PBX Configuration—[1-5] System—Timers
2.3.1 PBX Configuration—[2-1] Extension—Port
3.8.3 Call Transfer-Blind
Description
The Function to Transfer an external line or an extension in communication to another extension without
confirming the ring back tone of the outgoing call to the Transfer destination.
This feature is only available for SIP extensions. (For general SIP phones, the operation differs depending
on the phone.)
Operation
Perform Call Transfer-Blind using the following procedure: (For KX-HDV series only)
1.
Press the [Blind] Key
2.
Dial the transfer destination number and go on-hook.
[Transfer Recall]
•
If a transfer destination does not answer within a certain length of time, the call will ring at the extension
of the person who made the transfer operation. For more information, refer to 3.8.2 Call Transfer-
Unscreened.
3.8.3 Call Transfer-Blind
56
Feature Manual
Summary of Contents for KX-HTS824
