Panasonic KX-HTS824, Feature Manual

Page: 40 / 80

Conditions
Conditions Note
Trunk line numbers can be referred on a trunk port basis.
Each trunk can be disabled by setting Attribution to No Connect in
Web Maintenance Console.
In the Web Maintenance Console setting, the installer can specify
the Idle Line Access number to be used for each extension. Refer to 2.3.1 PBX Configuration
—[2-1] Extension—Port-1.Port
－
Main-Trunk Call Block in
Programming Item List.
PIL Reference
2.4.1 PBX Configuration—[3-1] Trunk—Port
3.2.5 Calling Line Identification Presentation (CLIP)
Description
When calling to a SIP Trunk line, notifies a CLIP number set for each extension as the caller's number.
It is possible to notify the name information set for each extension as well.
When a CLIP number is not set for a calling extension, the Subscriber Number for each SIP Carrier will be
notified.
Conditions
Conditions Note
When executing Walking COS, a CLIP set for the extension
specified by Walking COS is used. Refer to 3.4.2 Walking COS (TRS
level)
When an outgoing call to an extension is forwarded to a trunk, the
CLIP and the name of the caller is notified to the trunk.
When an incoming trunk call is forwarded to a trunk, the CLIP and
the name of the extension set for forwarding is notified to the trunk. However, when forwarding from a
SIP carrier to the same SIP
carrier, the Caller ID and name
information received from the SIP
carrier are notified as they are.
Refer to 3.1.7 Caller ID
PIL Reference
2.3.1 PBX Configuration—[2-1] Extension—Port
2.4.7 PBX Configuration—[3-7] Trunk—SIP Trunk Property
3.2.5 Calling Line Identification Presentation (CLIP)
40 Feature Manual