Setup overview
1
Initial setup
Make sure you can access the
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
2
Insert the battery
The sensor is battery powered.
3
Registration
Required only if the sensor was
purchased separately (i.e., not as
part of a bundle).
4
Confirm the installation area
Read the information in this
document to confirm that the
desired installation area is suitable
to proper operation.
5
Installation
Install the sensor in the desired
location.
Inserting the battery
R
Use ONLY a CR2 Lithium battery.
R
Confirm the polarities (
,
).
1
Remove the front cover.
R
Lift from the indented area (
A
)
and remove the cover (
B
).
A
B
2
Insert the battery.
3
Attach the front cover.
For assistance, visit www.panasonic.ca/english/support
9
Setup
HNS107C_(en_en)_0212_ver.011.pdf 9
2016/02/12 9:35:26
