Panasonic KX-HNC710W, Installation Manual

Page: 16 / 44

Turning the power
on for the camera
Open the cover of the camera,
and then slide the power slide
switch (page 13,
J ) to ON .
Registering the
camera
Before you can use the camera, it
must be registered to the access
point.
You can register each camera by
using the registration buttons or
the
[HomeHawk] app.
Note:
R Before registering the camera,
make sure the camera is turned
on, and that the AC adaptor of
the access point is connected
and the access point is
powered.
Using registration buttons
1
Access point:
Press and hold M SETUP N until
the LED indicator (
1
) blinks
slowly in green.
1
2
Camera:
Press and hold M SETUP N until
the LED indicator (
2
) blinks
slowly in green.
2
R When registration is
completed, the camera
sounds one long beep.
Note:
R If registration fails, the camera
sounds several short beeps.
Using the app
You can change the name of the
camera using the
[HomeHawk]
app. For more information, refer to
the User’s Guide (page 20).
16 For assistance, please visit http://shop.panasonic.com/support
Setup
HNC710_(en_en)_0207_ver.110.pdf 16 2018/02/07 20:11:47