Panasonic KX-HDV430, Administrator'S Manual

Page: 13 / 336

4.
Tap or to select
"IPv6 Settings"
.
5.
Tap or to select
"Connection Mode"
.
6. Select
"DHCP"
, and then tap
"OK"
7.
Tap or to select
"DNS"
.
8.
Select
"Auto"
, and then tap
"OK"
.
•
Select
"Manual"
to enter the addresses for DNS1 (primary DNS server) and, if necessary, DNS2
(secondary DNS server) manually, and then tap
"OK"
.
To configure network settings automatically using RA
1.
In standby mode, tap or to select
"System Settings"
.
2. Tap
"System Settings"
.
3. Tap
"Network Settings"
.
4.
Tap or to select
"IPv6 Settings"
.
5.
Tap or to select
"Connection Mode"
.
6. Select
"RA"
, and then tap
"OK"
7. Enter the addresses for DNS1 (primary DNS server) and, if necessary, DNS2 (secondary DNS server)
manually, and then tap
"OK"
.
To configure network settings manually
1.
In standby mode, tap or to select
"System Settings"
.
2. Tap
"System Settings"
.
3. Tap
"Network Settings"
.
4.
Tap or to select
"IPv6 Settings"
.
5.
Tap or to select
"Connection Mode"
.
6. Select
"Static"
, and then tap
"OK"
7. Enter the IP address, subnet mask, default gateway, DNS1 (primary DNS server), and, if necessary,
DNS2 (secondary DNS server), and then tap
"OK"
.
Note
•
If your phone system dealer/service provider does not allow you these settings, you cannot change
them even though the unit shows the setting menu. Contact your phone system dealer/service
provider for further information.
•
If you select
"DHCP"
for the connection mode, all the settings concerning static connection will be
ignored, even if they have been specified.
•
If you select
"DHCP"
for the connection mode and
"Auto"
for DNS, the DNS server settings (DNS1
and DNS2) will be ignored, even if they have been specified.
1.1.4 Overview of Programming
There are 3 types of programming, as shown in the table below:
1.1.4 Overview of Programming
Document Version 2016-05 Administrator Guide 13