Panasonic KX-FP701LA, Service Manual

Page: 96 / 207

96
KX-FP701LA
12.4. Remote Programming
If, after the call is connected, the customer describes the situation and it is determined that the problem can be corrected by
making parameter changes, this function makes it possible to change parameters such as the user code and service code from
another fax (using DTMF tones). Therefore, travel to the customer's location is not required. However, it is not possible to
change all the parameters remotely (
12.4.2.Program Mode Table (P.97)). The function used to accomplish this is remote pro-
gramming.
First, in order to check the current status of the service code parameter, print out the setup list (code: 991) and the service list
(code: 999) from the customer's fax machine.
Based on this, the parameters for the desired codes can be changed.
The procedure for changing and listing parameters is described on
12.4.1.Entering the Remote Programming Mode and
Changing Service Codes (P.96). Also, before exiting the remote programming mode, it is advisable to obtain a new list to con-
firm that the changes were made correctly.
Hints:
Since the connected telephone is in use during the remote programming mode, it may be helpful to ask the customer to switch
to the speakerphone. This frees the customer from the need to remain right next to the fax while you are making parameter set-
tings. When finished, inform the customer. Also note that in very noisy locations where the DTMF tones are not audible, the
remote programming function will not work.
12.4.1. Entering the Remote Programming Mode and Changing Service Codes
Note:
(*1): Refer to 12.4.2.Program Mode Table (P.97)