KW1M-H Eco-POWER METER
12
Chapter 4 Settings
4.1 Operation procedure
【
Basic setting to measure
】
When wiring Eco-POWER METER and CT and setting mode 1 after power on, Eco-POWER Meter can
measure the electric power. In order to use the other functions, set mode2, 3 and 4 according to your use.
Monitor (Display when power on)
Mode 1
…
Mode for setting each parameter for power
With SD
Memory card
<MODE>
measurement
without SD memory card
Setting mode
(SD Eject)
(Mode 1)
(Mode 2)
(Mode 3)
(Mode 4)
<SET>
<SET>
<SET>
<SET>
<SET>
Phase/Wire system
SYST
Refer to the next page.
<SET>
CT type
CT-T
<SET>
When select
‘5A’
Primary side current of CT
CT-1
Remove
SD
memory
When select
other than ‘5A’
<SET>
card
Voltage range
VOLT
<SET>
<SET>
VT ratio
VT
<SET>
Current for time
measurement
HM-A
<SET>
Cutoff current
CUTA
<SET>
Unit for pulse output
PL-P
When select
‘Values’
or ‘DEM’
When select ‘AL-P’
<SET>
When select ‘AL-C’
<SET>
When select ‘AL-S’
<SET>
When select ‘Cnt’
<SET>
or ‘P-THR’
<SET>
Power alarm
AL-P
Current alarm
AL-C
Stand-by alarm 1
AL-S 1
Preset value
Cnt
<SET>
<SET>
<SET>
Stand-by alarm 2
AL-S 2
<SET>
Demand alarm
DEM1/DEM2/DEM3
<SET>
<SET>
Electricity rate
RATE
<SET>
Conversion factor
CO2
<SET>
Press <MODE> to return Monitor.
Note) Press <MODE> and <SET> at the same time, the setting
will be initialized.
Monitor
