95
3.33 Skew Stop
This function stops the scanning when the paper fed by ADF is significantly skewed.
IMPORTANT NOTES:
•
The Skew Stop function does not work if the paper width is less than 148 mm.
•
When Skew Stop has been activated, open the scanner door and remove the
paper remaining inside. Then compare the document against the actually scanned
data, and re-install the paper up to the appropriate page. Scanning may not have
been completed for some pages of the document remaining inside the scanner.
ISIS configuration method
1
Set the [Skew Stop] check box in the [Reading Mode] section of the [Advanced
Settings] dialog box to on.
S7065C
SS905C
