Panasonic KV-S8147, Operating Manual

Page: 28 / 104

5.3.1.2 Changing the paper thickness mode
You can select the paper thickness mode depending on the thickness of the document to prevent double
feeding or paper jams.
For details about operation panel, refer to "5 Operation Panel" (page 20).
When the Home screen is on the LCD, press or of the cursor button to select one of the paper
thickness modes.
You can select one of the following paper thickness modes. The default setting is "Standard paper mode".
Paper thickness mode LCD display Purpose
Thin paper mode
(20 g/m² – 50 g/m²)
(5.2 lb. – 13.3 lb.)
Use when scanning thin paper or paper with a
rough surface.
(carbonless paper, etc.)
Standard paper mode
(40 g/m² – 157 g/m²)
(10.6 lb. – 41.8 lb.)
Use when scanning paper of standard thicknesses.
(copy paper, etc.)
Thick paper mode
(157 g/m² – 255 g/m²)
(41.8 lb. – 68 lb.)
Use when scanning thick paper or paper with a
smooth or shiny surface.
(post cards, drawing paper, etc.)
Automatic mode
(20 g/m² – 255 g/m²)
(5.2 lb. – 68 lb.)
Use when scanning paper of varying thickness.
(The scanning speed will be slow.)
Notice
•
The paper thicknesses in the table above are based on high-quality woodfree paper. Documents may
not feed correctly depending on the type of paper used. If that is the case, change the paper
thickness mode, and scan again.
Note
•
The paper thickness mode is enabled when automatic feeding is set.
5.3.2 Job screen
The Job screen is displayed when pressing the Job button ( ). For details about job selection, refer to
steps 1 to 4 in "7.3.2.1 Performing push scan" (page 59).
5.3.2 Job screen
28