Panasonic HYBRID IP-PBX KX-TDA100, Feature Manual, Page: 248 / 364

1.13 P
248 Feature Manual
channel will be released immediately. Since the PS can only be set to In Range at a single PBX at one time,
any other PBXs to which the call is transferred will refuse the call, releasing the VoIP or ISDN channels.
Conditions
• Hardware Requirement
The KX-TDA6920, KX-TDA0920 or KX-TDA5920 SD Memory Card for Software Upgrade to Enhanced
Version
• If no signal is received from a PS for the preprogrammed length of time when an incoming call is
received, the communication status of the PS is set to Out of Range, if enabled through system
programming.
• When a PS comes within range of a certain PBX, Out of Range status is automatically released.
However, in some negative wireless network conditions, Out of Range status may not be released
automatically. In this case, the PS user can manually release Out of Range status by pressing the Talk
key and confirming that a dial tone can be heard from the PBX.
• If the status of a PS is set to Out of Range at all PBXs that it is registered to, the call will be redirected
to the overflow destination of the ICD Group.
• Handover from one PBX to another PBX during a conversation is not possible.
Programming References
PC Programming Manual
2.8.4 [2-3] Timers & Counters—Miscellaneous—System Wireless—PS Out of Range Timer
2.8.17 [2-9] System Options—Option 4—System Wireless—Out of Range Registration
2.9.9 [3-5-1] Incoming Call Distribution Group—Group Settings—Main
→
Floating Extension Number
→
Distribution Method
2.9.12 [3-5-4] Incoming Call Distribution Group—Member
PT Programming Manual
[620] Incoming Call Distribution Group Member
[622] Incoming Call Distribution Group Floating Extension Number
[624] Incoming Call Distribution Group Distribution Method
Feature Manual References
1.9.4 ICD Group Features—Outside Destinations
1.13.18 PRIVATE NETWORK FEATURES—QSIG
Description
QSIG is a protocol which is based on ISDN (Q.931) and offers enhanced PBX features in a private network.
The QSIG network supports private communications by the TIE line service method.
The following features are available for an ISDN-QSIG or VoIP private network. For ISDN, system
programming is required to specify whether each feature (excluding Calling Line Identification Presentation
[CLIP]) is available for each port of the private network.
[Standard Service Table]