Panasonic HYBRID IP-PBX KX-TDA100, Feature Manual, Page: 241 / 364

1.13 P
Feature Manual 241
PT Programming Manual
None
Feature Manual References
1.19.4 Voice Mail DPT (Digital) Integration
1.13.15 Private Network Features—NDSS (Network Direct Station
Selection)
Description
When PBXs are networked using ISDN or IP-GW cards, it is possible to assign flexible buttons as Network
Direct Station Selection (NDSS) buttons. These buttons are used to monitor the status of extensions
connected to up to seven other PBXs in the network, and to make or transfer calls to those extensions with
one touch, like normal DSS buttons. This allows operator functions to be centralized even when there are
offices in remote locations.
NDSS buttons show the status of the monitored extension as follows:
[Example Network]
[Programming Procedure]
1.
Routing Table Assignment
TIE Line Routing and Modification tables must have been programmed in advance for all PBXs in the
network, to allow calls to be made and transferred between PBXs (
→
1.13.13 PRIVATE NETWORK
FEATURES).
In the programming example that follows, the PBXs in the network use the Extension Number method,
as shown in the illustration above. However, the PBX Access Code method can also be used.
Light pattern Status
Off The monitored extension is idle.
Red on The monitored extension is busy or has set DND for CO line calls.
PBX-1
Network ID 1
PBX-2
Network ID 2
2001 (busy)
2002 (idle)
4001 (idle)
PBX-3
Network ID 0
PBX-4
Network ID 3
Extn. 2001
Extn. 2002
Extn. 4001
1001 (busy)
Extn. 1001
Extn. 2002
Monitor extension
Monitor
extension