Panasonic HYBRID IP-PBX KX-TDA100, Feature Manual, Page: 206 / 364

1.13 P
206 Feature Manual
[801] External Modem Control
[810] Remote Programming
[811] Modem Floating Extension Number
[812] ISDN Remote Floating Extension Number (KX-TDA100/KX-TDA200/KX-TDA600 only)
Feature Manual References
1.4.5 DID (Direct Inward Dialing)
1.4.6 DIL (Direct In Line)
1.13.3 Password Security
1.13.7 PDN (Primary Directory Number)/SDN (Secondary
Directory Number) Extension
Description
Primary Directory Number (PDN) buttons and Secondary Directory Number (SDN) buttons are ideal for use
between bosses and secretaries. When a call (intercom or CO) arrives at a PDN button on the boss's
extension, the call will ring and the LED of the SDN button will flash at the secretary’s extension as well,
indicating that an incoming call is arriving at the boss’s extension. In addition, caller information (e.g., Caller
ID) of the incoming call will appear on the secretary’s extension. The secretary can answer the call for the
boss by simply pressing the SDN button. Delayed ringing can be set for a PDN or SDN button.
A secretary can hold a call answered on the SDN button, and the boss can retrieve the held call simply by
pressing the PDN button, like when answering a call with an S-CO button. In addition, a secretary can
transfer calls from an SDN button or other button (e.g., S-CO button) to the boss’s extension with a simple
operation, like when using a DSS button.
An extension can have several SDN buttons, each registered to a different boss’s extension. However, only
one SDN button can be registered for a single boss at each extension. An extension can have up to eight
PDN buttons. PDN buttons can simplify the use of an extension because both intercom and CO line calls
can be made and received at a PDN button.
This feature is only available for MPR Software File Version 3.1000 or later.
Making Calls with an SDN Button
When Standard SDN Key mode is assigned to an SDN extension (secretary) through COS programming,
SDN extensions (secretaries) can make calls for PDN extensions (bosses) on the SDN button. For example,
a boss can ask a secretary to make a call and put the call on hold, after which, the boss can retrieve the
held call.
Through COS programming, it is possible to allow an SDN extension to make calls using the COS of the
PDN extension. All other settings that are available when using the Walking COS feature are also applied
(
→
1.20.1 Walking COS).
SDN Direct Dial
An SDN extension can call a PDN extension or transfer a call to a PDN extension using an SDN button.
In this case:
– Only the PDN extension rings (i.e., other SDN extensions do not ring).
– The delayed ringing and DND settings of the PDN extension are ignored.
Depending on the mode selected through COS programming, SDN Direct Dial is performed in one of two
ways, as follows: