Panasonic HDC-SD1, Operating Instructions Manual

Page: 41 / 140

41
VQT1A24
Setup
Setting date and time
When the unit is turned on for the first time, a
message asking you to set the date and time will
appear.
≥
Move the cursor button up or down to select
[YES], press the center of the cursor button and
then perform steps 2 and 3 below to set the
date and time.
If the screen shows the incorrect date and time,
then adjust it.
¬
Rotate the mode dial to select .
1
Press the MENU button, then
select [BASIC]
#
[CLOCK SET]
#
[YES] and press the cursor
button.
2
Move the cursor button left or
right to select the item to be set.
Then, move the cursor button up
or down to set the desired value.
≥
The year will change as follows:
2000, 2001, ..., 2039, 2000, ...
≥
The 12-hour system is used to display the
time.
3
Press the cursor button to enter
the selection.
≥ The clock function starts at [00] seconds
when the cursor button is pressed.
≥ After pressing the MENU button to finish
the setting, check the date and time
display.
Changing the date and time display style
Press the MENU button, then select [SETUP]
#
[DATE/TIME]
#
desired display style and press
the cursor button.
≥
You can also show or change the date and time
display by repeatedly pressing the DATE/TIME
button on the remote control.
Changing the display style
Press the MENU button, then select [SETUP]
#
[DATE FORMAT]
#
desired display style and
press the cursor button.
≥
The date and time function are driven by a
built-in lithium battery.
≥ Make sure to check the time before recording.
≥ If the time display becomes [- -], the built-in
lithium battery has run down. Use the following
steps to charge the battery. When you turn on
the power for the first time after charging, a
message asking you to set the date and time
will appear. Select [YES] and set the date and
time.
To recharge the built-in lithium battery:
If you connect the AC adaptor or insert the
battery in this unit, the built-in lithium battery will
be recharged. Leave the unit as it is for approx.
24 hours and the battery will save the date and
time for approx. 6 months. (The battery is still
being recharged even if the mode dial is set to
OFF.)
[DATE] [D/T]
[OFF]
Display style Screen display
[Y/M/D] 2007.12.15
[M/D/Y] DEC 15 2007
[D/M/Y] 15.12.2007
DEC 15 2007 3:30PM DEC 15 2007
VQT1A24_ENG_PP.book 41 ページ ２００７年１月２１日 日曜日 午後１時１７分