DA-PU100 Series Administrator's Manual
30
3.3
Monitoring Tool
It periodically monitors the PHY rate of the PLC adaptor in the range specified by the IP address,
and it is possible to notify the administrator of the abnormality when it falls below the set value.
3.3.1
Setting up the monitoring tool
(1)
Check box for subnet network
･
Monitors the range of HD-PLC within the subnet network.
(2) Check box for specified range
･
Sets the specified range of the monitored target.
(3) Text box for setting a
specified range (IP)
･
Sets the start IP address and end IP address of the monitored target.
(4) Check box for specified
list
･
Sets the range to be monitored with the list.
(5) Text box for select
file
･
Sets the range of addresses written in the setting file (CSV format).
(6) Text box for setting the comm speed check cycle
･
Sets the monitoring period (in minutes).
(7) Text box for setting the lower limit speed
・
Sets the lower limit speed (in Mbps) used for measuring communication speed.
（
1
）
（
2
）
（
3
）
（
4
）
（
5
）
（
6
）
（
7
）
（
8
）
（
9
）
（
10
）
（
11
）
（
12
）
（
13
）
（
14
）
（
15
）
（
16
）
（
17
）
（
18
）
Summary of Contents for HD-PLC DA-PU100
