Panasonic HC-WXF1, Operating Instructions Manual

Page: 35 / 288

- 35 -
1
Open the LCD monitor or extend the
viewfinder to switch to Still Picture
Recording Mode. (
l
22 )
2
Press the button halfway. (For
Auto Focus only)
Focus indication:
3
Press the button fully.
≥ If you set the Optical Image Stabilizer function ( l 91 ) to ([MODE1]), then the Image
Stabilizer function will be more effective. ( (MEGA Optical Image Stabilizer) will be
displayed when the button is pressed halfway.)
≥ Using a tripod is recommended when recording still pictures in dark places because the shutter
speed becomes slow.
≥ You can also take a picture just by touching the subject to focus. (Touch Shutter: l 93 )
≥
The focus indication and the focus area may not be displayed depending on the recording
conditions or the menu settings.
∫
To set the desired Fn button as the Photoshot button
( series/ series)
You can also change the [FN BUTTON SETTING] so you can use the desired Fn button as a
Photoshot button. (
l 115 )
≥ The function where Auto Focus works when the Photoshot button is pressed halfway in step 2 is
enabled when [
] is set in the [Fn3] (Fn3 button).
Basic
Recording still pictures
A
Focus indication:
±
(The white lamp flashes.): Focusing
¥ (The green lamp lights up.): When in focus
No mark: When focusing is unsuccessful.
B
Focus area (area inside brackets)
: [SETUP] # [FN BUTTON SETTING] # [Fn1] to [Fn4] # [ ]


MEGA
WXF1 VXF1
MENU
HC-WXF1-VXF1-VX1-V800EBEP-DVQP1585_eng.book 35 ページ ２０１８年２月２２日 木曜日 午後１２時３０分