- 207 -
∫
It is not a malfunction in following cases
Troubleshooting
A clicking sound is heard
when the unit is shaken.
≥
This is the sound of the lens moving and is not a defect.
This sound will no longer be heard when the unit is turned on
and set this unit to the Motion Picture Recording Mode or Still
Picture Recording Mode.
Object seems to be
warped.
≥
Object seems to be warped slightly when the object moves
across the image very fast, but this is because the unit is
using MOS for the image sensor. This is not a malfunction.
White round spots like
soap bubbles appear on
the recorded picture.
≥
If you take a picture with the
flash in a dark place or
indoors, white round spots
may appear on the picture
caused by the flash
reflecting of particles of dust
in the air. This is not a
malfunction.
A characteristic of this is that the number of round spots and
their position differ in every picture.
The lens or LCD monitor
fog up.
≥
This is due to condensation. It is not a malfunction. Please
refer to page
.
Power
Problem
Check points
This unit cannot be turned
on.
This unit does not stay on
long enough.
Battery runs down quickly.
≥
Charge the battery again to ensure it is sufficiently charged.
(
)
≥
In cold places, the battery using time becomes shorter.
≥
The battery has a limited life. If the operating time is still too
short even after the battery is fully charged, the battery has
worn out and needs to be replaced.
This unit is turned off
automatically.
≥
If the unit turns off when you turn off the power to the TV
using the TV remote control, the VIERA Link is at work. If you
are not using the VIERA Link, set [VIERA Link] to [OFF].
(
)
This unit cannot be
operated though it is
turned on.
This unit does not operate
normally.
≥
Remove the battery or AC adaptor, wait about 1 minute and
then reconnect the battery or AC adaptor. Then about
1 minute later, turn on the unit again. (Conducting the above
operation while the media is being accessed may damage the
data on the media.)
≥
If normal operation is still not restored, detach the power
connected, and consult the dealer who you purchased this
unit from.