6
4
Press the jog switch to confirm settings.
5
Press <MODE> briefly at any time to move up one level. Press <MODE>
for 2s to return to RUN mode.
PRO1
PRO2
PRO2 mode is used to control the display.
Mode
Setting
Description
Ultra high speed
Response time 65
μ
s or less.
Fast
Response time 150
μ
s or less.
Reduced inten-
sity
*1
Response time 250
μ
s or less.
Standard
Response time 250
μ
s or less.
Long-range
Response time 2ms or less.
No timer
_
OFF-delay timer
*2
Extends the output signal for a fixed
period of time.
This function is useful if the output
signal is so short that the connected
device cannot respond.
ON-delay timer
Neglects short output signals.
This function is useful for detection if
a line is clogged, or for sensing only
objects that take a long time to travel.
One-shot timer
Outputs a fixed width signal upon
sensing.
This function is useful when the input
specifications of the connected
device require a signal of fixed width.
Small.
The optimal limit of detection range.
Standard
Large.
Capable of detecting objects that
vibrate.
Margin width ±5%
*3
The margin is the smallest, hence the
range in which the stability indicator
will light up is largest.
Margin width ±10%
Factor setting. Medium range.
Margin width ±15%
The margin is the largest, hence the
range in which the stability indicator
will light up is smallest.
(Factory setting.)
For limit teaching (+, -), you can shift,
i.e. offset, the theshold value by 0 to
80% in increments of 5%.
•
Reflective type fiber
. If the
threshold value is shifted toward
the “-” direction, minute detections
are possible.
•
Thru-beam type fiber
. If the
threshold value is shifted toward
the “+” direction, minute detections
are possible.
*4
Level 4. Highest emitting power.
Level 3.
Level 2.
Level 1. Lowest emitting power.
Emission halt.
While in RUN mode,
is displayed
when the emission halt state is valid.
*1
The S-d setting is suitable for delicate sensing, such as when the received
light is saturated due to an insufficient sensing distance or when detecting
translucent objects, etc.
*2
The range starts at 0.5ms, and then proceeds from 1 to 9999ms in 1ms
intervals.
*3
*4
The levels that can be selected vary depending on the response time.
Mode
Setting
Description
The incident light intensity is displayed.
Percent above threshold value.
This function displays the incident light inten-
sity within a range of 1P (1%) to 999P
(999%) using the threshold value as refer-
ence.
Peak hold display.
This function displays the peak numerical
value of the incident light intensity. It is
refreshed continuously.
Bottom hold display.
This function displays the bottom numerical
value of the incident light intensity. It is
refreshed continuously.
The direction of the digital display is normal.
The direction of the digital display is inverted.
ECO mode is OFF.
ECO mode is ON.
When ECO mode is ON, the display turns off after
20s in RUN mode. To reactivate the display, press
any key for 2s.
Mode
Setting
Description
0
4,000
Output operation
Stability indicator, ON/OFF
Margin
Threshold
value
Incident light
intensity
Light
received
Light
interrupted
ON
OFF
ON
Margin
