3-7
Preventive
Maintenance
(9) Removal of the paddle roller
1) Remove the front and rear cover.
2) Remove the CPU PCB mounting bracket.
3) Remove the upper left panel. (2 screws.
Shoulder screw on the front side)
4) Disconnect the sensor connector.
5) Remove the sensor harness from the
harness clamp.
6) Remove the upper guide plate for the
invert paper exit. (4 screws)
7) Remove the invert guide plate. (4 screws)
8) Remove the tension spring. (2 positions,
front/rear).
NOTE: Use the upper hole when the spring
is reinstalled.
9) Remove the gear and bushing.
(front/rear, 1 E-ring each)
10) Remove the paddle roller.
3
3
6
5
6
4
7
7
8
8
9
10