21
Operation Manual
FT1020G3 Rev 2.10.4
Table 6 Push buttons / keypad on Control Panel (CP)
Key/push button
Operation/function
(Enter)
Used to accept / select a menu or input of data. Also
used to acknowledge fault signal and service signal.
◄
► ▲ ▼
Left / right keys used to move the cursor in a menu.
Up / down keys used to scroll between the menus.
0 - 9
Numeric key pad for the digits 0-9. Can be used to
input data and in the menu system to jump to a menu
with a corresponding number (e.g. 5 for a jump to
menu H5).
DEL
Used to clear /delete all visible entry fields.
ESC
Used to stop input of data or to step upwards "one
step up" in the menu system (e.g. from a sub menu
to the main menu).
3.4.2
The Display (LCD)
3.4.2.1 Areas in the Display
The display is split to three areas:
•
Symbol area:
Some events are indicated with symbols, see Table 7 below.
•
Information area:
General area for all other information and the menu system.
•
Soft key area:
The functions of the soft keys are shown in the bottom section of
the display. The soft keys will vary depending on the system condition and
convention. If no text is shown, the soft key has no function. The last soft key is
used to acknowledge an "Alert Annunciation” alarm (if programmed). In the New
Zealand convention, it is used to "Acknowledge Alarm".
Silenced Alarms are indicated by the symbol
to the right in this area.
Symbol area
Information area
Soft key area
Menu
Next zone
Re-enable
Alert annunc.
Summary of Contents for Firetracker FT1020G3 CIE
Page 1: ...Operation Manual FT1020G3 Rev 2 10 4 For Software V2 10 4 FT1020G3 FDCIE MA430 March 2023...
Page 2: ...This page has deliberately been left blank...
Page 176: ...176 Operation Manual FT1020G3 Rev 2 10 4 Figure 24 FT1020G3 Standard Block Wiring Diagram...
Page 177: ...177 Operation Manual FT1020G3 Rev 2 10 4 Figure 25 FT1020G3 New 5012 PCB Layout...
