26 - ENGLISH
Installation (continued)
360°
Ball joint movement range:
Approx. 90°
When you loosen the two ball joint
fi
screws, the ball joint can move freely.
This allows you to rotate the main unit 360° or
tilt the main unit 90° with the ball joint moving
part.
3) Tighten the
fi
xing screws.
While supporting the main unit, securely tighten the rotating
fi
xing screw and two ball joint
fi
xing screws
with the allen wrench (3.0 mm [1/8"] across
fl
ats) supplied with the projector.
Attention
The main unit and power supply section of the projector are connected by a cable, etc. Do not rotate and
change the tilt of the main unit more than necessary.
Attention
The rotating
fi
xing screw and ball joint
fi
xing screws are hexagon socket head screws (M6). Take care because
they will come out of the projector if loosened too much.
After making rough adjustments, refer to the operating instructions of the projector and then
fi
nely adjust the
projection position, focus, and projection screen size while actually projecting images. If necessary, also correct
any keystone distortion.
ET-JPC100BWE(DPQX1105ZA)̲E.indd 26
ET-JPC100BWE(DPQX1105ZA)̲E.indd 26
2016/06/08 11:44:43
2016/06/08 11:44:43
