http://202.224.189.178/~sgml/viewing/EP1014-U1/NA/SVC/s1002000000.html
10.2 Removing the tapping shaft
assembly
1. Cut all the insulated ties bundling each sensor and lead wires with the aid of a nipper, and remove
the lead wires bundled to the wire saddles (medium, large).
2. Remove all the connectors to the main circuit board.
3. Remove the massage belt, up/down belt and intensity adjustment belt.
4. Remove the motor fitting set screws A to D, and remove the motor and tapping belt.
5. Remove the shield panel (fitted to the circuit) set screw E to J, and remove the shield panel and
eccentric shaft spring.
6. Remove the K type stop ring by using flat head driver.
7. Remove the screw K to M and remove the intensity adjustment block.
8. Remove the Pro tektite cover for eccentric link set screws N with a spanner, and remove the Pro
tektite cover for eccentric link and remove another screw O and the Pro tektite cover for eccentric
link.
9. Remove the guide plate for motor set screws P to R and the guide plate for gearbox set screws S
to V.
10. Slide out the tapping shaft assembly with tapping clutch and the guide plate for gearbox.
*Caution for assembling the pro tektite cover for eccentric spring.
<Assembly procedure>
A. The tapping shaft assembly should be mounted on massage mechanism, and put the
grease(WEP001Y8957) on the spring setting hole of pro tektite cover for eccentric spring
and set the one end of spring to hole as shown Figure.
B. Put the grease(WEP001Y8957) on the spring setting hole of Shield panel for PCB and set
http://202.224.189.178/~sgml/viewing/EP1014-U1/NA/SVC/s1002000000.html (1 of 3) [12/6/2003 9:48:54 AM]
