- 40 -
When the POWER LED is flashing other than
during power up or down of this unit, check the
message on the TV screen. If a message is not
displayed on the TV screen, determine the type of
the error by checking the way the POWER LED is
flashing.
(Flashes 6 times)
h
The remote control and this unit are using
different codes.
Turn on this unit by using [
Í
/I] on the main
unit, and check “Remote Control
” which is
displayed on the screen when you press a
button on the remote control.
Press and hold [OK] and the displayed
number (“
”) for at least 5 seconds.
(Flashes 4 times)
h
The unit fails to operate properly. Press [
Í
/I]
on the main unit for 3 seconds to switch the
unit to standby, then switch back on.
(Flashes)
h
The copyright protected disc cannot be
played back.
One of the devices connected to this unit (TV,
amplifier, etc.) does not support copyright
protection.
h
Temperature of this unit is hot and the unit
switches to standby for safety reasons.
Wait for about 30 minutes.
Install or place this unit with good ventilation.
h
A firmware update is in progress.
(Flashes 3 times)
h
The disc in use cannot be played back since
the copyright information is invalid.
h
A firmware update using a USB device is
complete.
POWER LED
Symbols indicate the following states:
Flash
No illumination
Repetition
