Panasonic DMR-UBS80EG, Service Manual

Page: 38 / 93

38
6 Installation Instructions
Note:
In this document, explanations basically use illustrations of DMR-UBS90EG.
In other models, shape of some parts may be different.
6.1. Taking out the Disc from BD Drive Unit when the Disc cannot be ejected
by OPEN/CLOSE button
6.1.1. Forcible Disc Eject
6.1.1.1. When the power can be turned off.
1. Turn off the power, press and hold [OK], [BLUE] and [YELLOW] on the remote control at the same time for more than 5
seconds.-"00 RET" is displayed on the unit's display.
2. Repeatedly press [ ] on the remote control or [POWER] on the unit until "06 FTO" is displayed on the unit's display.
3. Press [OK] on the remote control or [OPEN/CLOSE] on the unit.
6.1.1.2. When the power can not be turned off.
1. Press [POWER] key on the front panel for over 4 seconds to turn off the power forcibly, press and hold [OK], [BLUE] and
[YELLOW] on the remote control at the same time for more than 5 seconds.
-"00 RET" is displayed on the unit's display.
2. Repeatedly press [ ] on the remote control or [POWER] on the unit until "06 FTO" is displayed on the unit's display.
3. Press [OK] on the remote control or [OPEN/CLOSE] on the unit.
6.1.2. When the Forcible Disc Eject can not be done.
1. Turn off the power and pull out AC cord.
2. Put deck so that bottom can be seen.
3. Slide SLIDE CAM by Paper Clip or minus screw driver (small) in the direction of arrow to eject tray slightly.
4. Put deck upward, and pick out Tray by finger.