Troubleshooting
Troubleshooting guide
The images do not appear on the TV.
The picture is distorted during play, or video
will not play correctly.
• Check the connections. (O 16)
• Check the settings of the connected TV, etc.
• An incorrect resolution is selected in “HDMI
Video Format”. (O 84, 94) Reset the setting
as follows:
1 While the unit is on, press and hold [OK],
the yellow button and the blue button at
the same time for more than 5 seconds.
• “00 RET” is displayed on the unit's
display.
2
Repeatedly press [1] (right) until “04
PRG” is displayed on the unit's display.
3 Press and hold [OK] for at least 3
seconds. Set the item again.
• When Dolby Digital Plus, Dolby TrueHD,
and DTS-HD audio are not output
properly, select “Yes” in “Default
Settings” and make proper settings. (O
84, 100)
• The unit's TV System is different from that of
the disc. While stopped, keep pressing [■]
(STOP) and [< OPEN/CLOSE] on the main
unit for 5 or more seconds. The system
switches from PAL to NTSC or vice versa.
• Picture may not be seen when more than
4 devices are connected with HDMI cables.
Reduce the number of connected devices.
• The picture may be distorted or a black
screen may appear between scenes
recorded with different aspect ratios.
• Set “Deep Colour Output” (O 84, 95) or
“Contents Type Flag” (O 84, 95) to “Off.
3D video is not output correctly.
• 3D video may be output correctly by
changing the following settings:
-
“3D Type” of “3D Settings” (O 94)
-
“Signal Format” (O 48, 3D settings during
playback)
• Check the settings of the connected TV.
• When
a
non-3D
compatible
amplifier/receiver is connected between this
unit and a TV, 3D video is not output. (O 18)
• When the amplifier/receiver which is
connected between this unit and a TV is off,
3D video is not output. (O 18)
• 3D discs may not be played back correctly
due to the settings of the TV.
• When “HDMI Audio Output” is set to “Off,
3D video may not be output correctly. (O 95)
•
The same video is displayed in each left and
right half of the screen.
• This is a 3D programme of the Side-by-Side
type.
Change the setting as follows if connecting
with a 3D compatible TV:
1 Press [OPTION].
2
Select “Playback Settings” in “Playback
Menu”, then press [OK].
3
Select “3D Settings”, then press [OK].
4
Select “Side by side” in “Signal Format”,
then press [OK].
108
VQT4W71
Summary of Contents for DMR-BCT730
Page 11: ...u r 10 VQT4W71 ...
