- 33 -
When the POWER LED is flashing, check the
message on the TV screen. If a message is not
displayed on the TV screen, determine the type of
the error by checking the way the POWER LED is
flashing.
Flashes 6 times
¾
The remote control and this unit are using
different codes.
Turn on this unit by using the standby/on
switch on this unit, and check “Remote control
”, which is displayed on the screen when
you press a button on the remote control.
Press and hold [OK] and the displayed
number (“
”) for more than 5 seconds.
Flashes
¾
The copyright protected disc cannot be
played back.
One of the devices connected to this unit (TV,
amplifier, etc.) does not support copyright
protection.
Flashes 3 times
¾
The disc in use cannot be played back since
the copyright information is invalid.
Messages on the screen
Cannot play.
¾
You inserted an incompatible disc.
Cannot play on this unit.
¾
You tried to play a non-compatible image.
¾
Re-insert the media.
No disc inserted.
¾
The disc may be upside down.
$
This operation is not available.
¾
Some operations are unsupported by the
unit. (For example, reverse slow motion, etc.)
IP address is not set.
¾
The “IP Address” in “IP Address / DNS
Settings” is “---. ---. ---. ---”. Set the “IP
Address”, “Subnet Mask”, and “Gateway
Address”. (Select the automatic address
acquisition if necessary.)
[BDT281/280]
The wireless access point currently has a low
network security setting. It is recommended
to change to a higher setting.
¾
Set a stronger network security level referring
to the wireless router operating instructions.
POWER LED