40
39
E
N
G
L
I
S
H
CQ-D1703W
Wiring
¡
Exclusively operated with 12 V battery with negative (–) ground.
¡
Connect the power lead (red) very last.
¡
Connect the battery lead (yellow) to the positive (+) terminal of the battery or fuse block terminal (BAT).
¡
Apply insulating tape to bare leads.
¡
Secure loosened leads.
Before Wiring
Connect as follows
¡
Use ungrounded speakers only.
Allowable input: 50 W or more
Impedance: 4 – 8
Ω
¡
Distance between speaker and amplifier: 30 cm or more
¡
Do not use a 3-wire type speaker system having a common
earth lead.
Caution
¡
Do not connect more than one speaker to one set of
speaker leads. (except for connecting to a tweeter)
Speaker Connection
–
+
PARKING BRAKE
The parking brake switch position varies with the car
model.
For details on the exact location of the parking brake
switch in your car, contact your dealer.
q
Attach a Clip Connector
y
to the end
of the parking brake connection lead.
w
The Clip Connector
y
is connected to
the power source side lead of the park-
ing brake.
Connecting the Parking Brake Connection Lead
Hand brake
Foot brake
Parking Brake Lead
(Blue/yellow stripe)
When the parking brake lever is
engaged, the unit is grounded by the
chassis.
Parking brake
switch
Car chassis
Battery
Brake light
Clip Connector
y
Parking Brake Lead
(Blue/yellow stripe)
Power source side lead
Caution
¡
For safety, be sure to ask your nearest professional installer to do this connection.
When connecting this unit to the rear monitor:
¡
The parking brake lead and grand lead should be connected to the same terminal.