39
The red indicator lights
The red indicator blinks
The orange indicator
blinks
T h e g r e e n i n d i c a t o r
blinks
The battery level is very low (the charge is less than approx. 9% capacity).
Connect the AC adaptor. You can use the computer when the indicator light is orange.
If you do not have an AC adaptor, save your data and power off your computer. After
replacing the battery pack with a fully charged one, turn your computer on.
Quickly save your data and power off your computer. Remove the battery pack and
disconnect the AC adaptor, then connect them again.
If the problem persists, contact Panasonic Technical Support. The battery pack or
recharging function may be defective.
Battery cannot be recharged temporarily because the internal temperature of the
battery pack is outside of the acceptable temperature range for recharging. Once the
allowable range requirement is satisfied, charging begins automatically. Your com-
puter can be used normally.
Battery is discharging to prescribed charging level in high temperature mode.
Battery Indicator
Dealing with Problems (Advanced)
Only capital letters are
being input
How to input European
characters (ß, à, ç), sym-
bols or Euro Currency
Symbol is unclear
Character Input
If
CapsLock
is on, the Caps Lock function is ON. To switch it OFF, press
Caps Lock
.
Select [Start] - [All Programs] - [Accessories] - [System Tools] - [Character Map].
The Character Map will be displayed. Point to the desired font name and select it.
Setup Utility
Enter the User Password or Supervisor Password. If you have forgotten it, contact
Panasonic Technical Support.
Restart the Setup Utility with the Supervisor Password.
Restart the Setup Utility with the Supervisor Password.
Restart the Setup Utility with the Supervisor Password.
[Enter Password] is dis-
played
[Advanced] menu can
not be registered
All or some items in [Se-
curity] menu can not be
registered
F9 does not work
Unable to connect to a
network
Confirm that [LAN] is set to [Enable] in the Setup Utility.
When using the computer as a network computer, some additional settings may
have to be made depending on the usage conditions. We recommend asking your
system administrator or the person in charge of the network.
If the standby or hibernation mode is entered, the computer may have to be restarted.
If the link lamp on the HUB unit is not on and the network cannot be accessed, set
the speed to match the HUB unit. (
page 26
)
Network
