– 170 –
Chapter 9 Notes — Warning system
Warning system
When an error is detected right after the camera is turned on or during the operation, occurrence of error is notified in the HOME screen, VIEW screen,
or by the tally lamp. Deal with the error by following the indications.
Cases indicated by error messages
System error
Screen display
Description
Behavior and cause
VIEW screen
HOME screen
[SYSTEM ERROR]
—
An error in the standard signal or communication
error has occurred.
All the tally lamps and the card access lamps
(orange) will flash four times a second, and an alarm
is sounded.
f
Set the power to < > (standby).
Warning
Screen display
Description
Behavior and cause
VIEW screen
HOME screen
[LOW BATTERY]
—
Remaining battery capacity is insufficient.
All the tally lamps and the card access lamps
(orange) will flash four times a second, and an alarm
is sounded.
The power status display becomes
, and it will
flash once every second in red.
f
The power is turned off in approximately five
seconds.
f
Replace with a fully charged battery, or connect
the AC adaptor.
[HIGH TEMPERATURE]
—
Displayed when the internal temperature of the
camera has risen above assumed.
All the tally lamps and the card access lamps
(orange) will flash four times a second, and an alarm
is sounded.
f
The power is turned off in approximately five
seconds.
f
Turn on the power again and check recording
and playback operations. If the problem persists,
consult the dealer.
[REC WARNING]
An error of the recording data has occurred during
recording, and the recording has stopped.
All the tally lamps and the card access lamps
(orange) will flash four times a second, and an alarm
is sounded.
f
Recording is stopped.
[REC WARNING]
It has tried to record exceeding the maximum
number of clips during recording.
All the tally lamps and the card access lamps
(orange) will flash four times a second, and an alarm
is sounded.
f
Recording is stopped.
f
When [DIAGNOSTICS] is selected in the INFO
screen, [REC WARNING] [<OVER MAX NUM. OF
CLIPS>] is displayed in the warning display area.
f
Replace the SD card or delete unnecessary clips.
[CARD ERROR <SLOT 1>]/
[CARD ERROR <SLOT 2>]
A data error caused by the SD card has occurred
during recording or playback.
f
When it was recording
All the tally lamps and the card access lamps
(orange) will flash four times a second, and an
alarm is sounded.
Recording is stopped.
After the recording is stopped, the SD card where
the error has occurred is write protected. Replace
the SD card in the card slot where the error
occurred.
f
When it was playing back
Playback is stopped.
[END]
(SD card status display)
—
The remaining recordable capacity of the SD card
has exhausted during recording.
All the tally lamps and the card access lamps
(orange) will flash four times a second, and an alarm
is sounded.
f
Recording is stopped.
f
Replace the SD card or delete unnecessary clips.
(Once every second, flash in red)
—
Battery is almost consumed.
All the tally lamps will flash once every second.
f
The current operation will continue.
f
Replace with a fully charged battery, or connect
the AC adaptor.
SD card remaining recordable
capacity display
(Flashes once every second
during recording)
—
The remaining recordable capacity of the SD is
getting low.
f
Recording will continue.
f
Replace the SD card as necessary.
