Panasonic AKW1110, User Manual

Page: 19 / 60

KW1M Eco
－
POWER METER
11
Chapter 4 Setting
4.1 Operation procedure AKW1111 (400VAC applicable type)
・
MODE1: for power measurement
・
MODE2: for pulse measurement
・
MODE3: for serial communication(RS-485)
・
MODE4: Setting for optional functions
Monitor
<MODE>
( 1 ) ( 2 ) ( 3 ) ( 4 )
<SET> <SET> <SET> <SET>
Phase/Wire system
setting mode
SYST
Max. measurement
speed setting mode
Hz
Protocol setting mode
PROT
Auto-off setting
mode
OFF
<SET> <SET> <SET> <SET>
CT type setting mode
CT-T
Prescale setting mode
PSCL
Station number
setting mode
NO
<SET> <SET> <SET>
Primary side current of
CT setting mode
CT-1 ＊ 1
Transmission speed
setting mode
SPD
<SET> <SET>
Voltage range setting mode
VOLT
Transmission format
setting mode
FMT
<SET> <SET>
VT setting mode
VT
Response time
setting mode
RESP
<SET> <SET>
Current for time
measurement setting mode
HM-A
<SET>
Cutoff current setting mode
CUTA
<SET>
Unit for pulse output
setting mode
PL-P
<SET>
Alarm value setting mode
AL - P/ AL-C / AL-S
＊ 2
<SET>
Preset value setting mode
Cnt
＊
2
<SET>
Electricity rate setting
mode
RATE
<SET>
Conversion factor setting
mode
CO2
Press <MODE> to
return Monitor.
<SET>
Monitor
＊ 1 Primary side current of CT setting mode is only when ‘5A’ is selected on CT type setting mode.
＊
2 Alarm value setting mode/Preset value setting mode is only when ‘AL-P’’AL-C’’AL-S’’ or ‘Cnt’ is
selected on Unit for pulse output setting mode.