7
Controls and their Functions
=
Alarm indication LED [ALARM]
It lights up when an alarm is generated (in case of fan stop, wrong communication
speed, etc.).
Note:
In case of wrong communication speed, change the DIP SW position in the unit to
match the camera and communication speed so that the alarm goes out.
>
Scene file select switch [SCENE]
Used to select the scene file previously set on the camera.
Note:
With [PRESET] selected, it results in the factory-adjusted setting.
?
Mode select switch [MODE]
Used to select the camera color bar signal, test signal and camera picture signal. With
the switch set to [BAR], [TEST], the color bar signal and the test signal are output from
the monitor signal output terminal of this unit. With it set to [CAM], the picture taken by
the camera is output.
@
Auto white start switch [AUTO WHITE]
With this switch pressed, the white balance is automatically adjusted. During the
operation, WHTE LED blinks, and it goes out when the adjustment is normally finished.
In case of NG, it lights up for a while and then goes out.
Note:
It does not operate when the mode is [BAR].
A
Auto black start switch [AUTO BLACK]
With this switch pressed, the lens is automatically closed, and the black balance is
adjusted. During the operation, BLACK LED blinks, and it goes out when the
adjustment is normally finished. In case of NG, it lights up for a while and then goes
out.
B
R/B gain adjust volume [GAIN]
Used to adjust the R/B signal gain of the camera.
C
R/B pedestal adjust volume [BLACK]
Used to adjust the R/B signal pedestal level of the camera.
D
ND filter select switch [ND FILTER]
Used to select the optical filter (ND) of the camera.
E
CC filter select switch [CC FILTER]
Used to select the optical filter (CC) of the camera.
Summary of Contents for AKHRP900P - CAMERA CONTROLLER HC
Page 22: ...22 Memo...
Page 23: ...23 Memo...
