Panasonic AK-UB300G, Operating Instructions Manual

Page: 91 / 110

– 91 –
Chapter 7 UB300 Setting Tool — Introduction
Introduction
UB300 Setting Tool is dedicated for AK-UB300G.
This operates in Windows and Macintosh.
Changing of the setting menu and updating of the firmware for AK-UB300G are possible.
r
Description in this document
Description in this document is common for both Windows and Macintosh. Unless it is noted specially, the contents of description is common for both
Windows and Macintosh.
The screenshots used in this document are for Windows7. The screen construction is common for both Windows and Macintosh, but the following parts
will differ.
f
The “minimize” and “close” buttons at the top of the window
Displayed position will be different for Windows and Macintosh.
f
The [OK] and [Cancel] buttons in the dialog
The display order will be different for Windows and Macintosh.
Also, the capture screen described in this document may differ from actual.
@ @ NOTE
t
Usage with multiple UB300 Setting Tool started simultaneously is not supported.
t
Open the receive port on the local host to operate the UB300 Setting Tool.
The receive port can be arbitrarily specified in the setting screen of UB300 Setting Tool.
Function of the UB300 Setting Tool
Connection setting
It can connect to any AK-UB300G by setting the connection information.
The items that can be set are as follows.
r
Camera information
f
IP address: Specify the IP address of AK-UB300G to connect.
f
Port number: Specify the port number of AK-UB300G to connect. The default for camera side is 80.
r
Authentication information
f
User name: Specify the account name with administrator privilege to be used at the time of connection.
f
Password: Specify the password for the account with administrator privilege to be used at the time of connection.
r
Local host information
f
Port number: Specify the port number that UB300 Setting Tool will use when it is to connect. It is not necessary to change if it is not required.
Once these items are set, click the [Connect] button to connect to the specified AK-UB300G.
Firmware update function
Update can be performed on the connected AK-UB300G by specifying an arbitrary firmware.
The firmware that can be updated are as follows.
f
CAM MAIN
f
NETWORK
f
ROM TABLE
f
CAM FPGA
f
AVIO FPGA
f
Option (enabled only when an option board is added)
Setting menu operation
Setting menu of the connected AK-UB300G can be operated.
The status of the displayed setting menu is synchronized with the connected AK-UB300G.
However, all setting menu items cannot be operated from this tool.
OSD operation function
The buttons for OSD menu operation for AK-UB300G can be executed.
Use this when performing OSD operation while viewing the image output from AK-UB300G.