Description of parts
39
Right side
Φ
1 Handle fitting
2 < > mark
Indicates the imaging plane inside the camera.
Rear side
1
2
10
7
6
3
4
5
9
8
AK-SHB800G
1
2
AK-SHB800PS
1 <OPT IN> terminal
Connect to the <OPT OUT> terminal on the IPU using an optical fiber cable.
@
@
NOTE
t
There is a protective cap on the terminal. Remove it before use.
2 <OPT OUT> terminal
Connect to the <OPT IN> terminal on the IPU using an optical fiber cable.
@
@
NOTE
t
There is a protective cap on the terminal. Remove it before use.
3 <DC IN> terminal
This is an input terminal for the external DC power supply. Connects to the external DC power supply.
(DC 11 V to 17 V)
For details, refer to “Using external DC power supply” (Page 13).
4 <OPT> lamp
This indicates the status of the optical signal reception level on the camera.
When the level is strong: Lights green
When the level is weak: Lights yellow
When there is no reception: Off
1
2
Operating Instructions
