– 53 –
Chapter 3 Preparation — P2 card
P2 card access LED
P2 card status
Mode check display*
Off
Card not supported
This card cannot be used on the camera. Replace the
card.
[NOT SUPPORTED]
Illegal format
The P2 card is not properly formatted. Reformat the card. [FORMAT ERROR]
No card
The P2 card is not inserted. The card is waiting to be
recognized.
[NO CARD]
Unauthenticated card
This microP2 memory card cannot be authenticated.
Select the main menu
→
[CLIP]
→
[AUTHENTICATE],
and enter the password.
For details, refer to “Manual CPS authentication”
[AUTH NG]
USB non-access
The P2 card cannot be accessed since the mode is the
USB device mode.
No display
P2 card recording time
r
P2 cards supported on the camera
The optional P2 memory cards and microP2 memory cards with a capacity of 30 GB to 64 GB can be used with the camera. (As of December 2018)
@
@
NOTE
t
2 GB cards cannot be used.
t
When AVC-Intra 200 and AVC-Intra 100 in 1080/59.94P or 1080/50P mode are selected, you cannot record to the following P2 cards.
- P2 memory cards of R, A, or E series
- microP2 memory card to which microP2 adaptor is attached
t
t
Refer to our support desk at the following website for the latest information not included in these operating instructions.
https://pro-av.panasonic.net/
r
P2 card recording times
(Example when a 64 GB card is used)
System mode
Recording format (codec)
Recording time
1080P
AVC-Intra 200 30PN
AVC-Intra 200 25PN
Approx. 32 min
AVC-Intra 100
Approx. 32 min
AVC-LongG 25
Approx. 128 min
AVC-LongG 12
Approx. 240 min.
1080i, 720P
AVC-Intra 200
Approx. 32 min
AVC-Intra 100
Approx. 64 min
AVC-Intra 50
Approx. 128 min
AVC-LongG 50
Approx. 128 min
AVC-LongG 25
Approx. 256 min
AVC-LongG 12
Approx. 480 min.
DVCPRO HD
Approx. 64 min
480i, 576i
DVCPRO50
Approx. 128 min
DVCPRO
Approx. 256 min
DV
Approx. 256 min
@
@
NOTE
t
The above table shows values for regular recording. With native recording, even longer recording times are available depending on the system mode.
t
Indicated capacities include management and other area, so the space available for recording is less than the values in the table above.
Dividing clips recorded on P2 cards
The recording is automatically continued as another clip when a single continuous recording time exceeds the following time, if a P2 card with a capacity
of 8 GB or larger is used on the camera. it can be operated as a single clip when the thumbnail operation (displaying, deleting, restoration, etc.) on the
P2 device is performed. Clips may be displayed as separate clips in nonlinear editing software or on a computer. When recording on a microP2 memory
card that exceeds 32 GB in AVC-LongG codec, the recording can be continued as a same clip by selecting [ONE FILE] from the main menu
→
[REC/
PB]
→
[REC/PB SETUP]
→
[FILE SPLIT]. Also, the clip will be divided into recording file of approximately 128 seconds each when the main menu
→
[REC/PB]
→
[REC/PB SETUP]
→
[FILE SPLIT] is set to [SHORT SPLIT], but it can be operated as a single clip when the thumbnail is operated on the
P2 device. The divided unit of the recording file becomes smaller when [SHORT SPLIT] is selected, making the transfer of the clip to start earlier when
the rec during upload function is used.
[SHORT SPLIT] is disabled during the interval recording, the one-shot recording, and the loop recording.
Recording format (excluding native recording)
Continuous recording time
AVC-Intra 200 (1080i)
AVC-Intra 100 (1080P)
Approx. 3 min
AVC-Intra 100 (1080i)
DVCPRO HD
Approx. 5 min
