– 228 –
Chapter 8 Network Connection — Preparing for connection
For wireless module other than AJ-WM30/AJ-WM50
Connect the wireless module other than AJ-WM30/AJ-WM50 (optional) to the camera.
Turn off the power of the camera before connecting or disconnecting the wireless module.
<USB2.0> terminal (sub-host)
Wireless module
Fig. 2
Fig. 3
Gap on the cover
Fig. 4
Fig. 5
Fig. 1
1
Open the cover. (Fig. 1)
2
Attach the USB 2.0 extension cable to the <USB2.0> terminal (sub-host). (Fig. 2)
3
Rotate the part at the bottom of the cover in the direction of the arrow (Fig. 3) and close the cover so that the USB 2.0 extension
cable goes through the gap. (Fig. 4)
4
Connect the wireless module. (Fig. 5)
@
@
NOTE
t
For the USB 2.0 extension cable (optional), using a cable of A type male/female, 0.5 m or shorter, and with double-shielded for noise suppression is
recommended.
t
For details on wireless modules that can be connected, refer to the support desk at the following website.
https://pro-av.panasonic.net/en/sales_o/p2/server/4glte.html
https://pro-av.panasonic.net/en/sales_o/p2/server/wireless_module.html
For wired LAN
Connect a LAN cable.
LAN cable (optional)
1
Connect the LAN cable to the <LAN> terminal on the rear side.