Panasonic AJ-PX380G, Operating Instructions Manual

Page: 106 / 229

– 106 –
Chapter 4 Shooting — Setting the time data
r When the camera recording format is 480i/576i
Camera usage conditions
Image and standard signals
supplied externally
SDI VIDEO
Genlock input SD (480i/576i)
Camera settings [GL PHASE] Disabled
Genlock input and camera
output phase
SDI output (HD) None
Video output and SDI output
(SD)
l
Time code output
l
Setting and displaying the counter
When the counter display is set by using the <COUNTER> button, the counter value is displayed on the time code display area of the viewfinder.
Counter value is displayed as “hour:minute:second.frame”. The counter value is also displayed during playback.
You can set either of two types in the main menu
→ [DISPLAY SETUP] → [REC COUNTER].
[TOTAL]: The camera will continuously count until it is reset with the <RESET> button. The counter value is retained even if the P2 card is replaced or
the power is turned off.
[CLIP]: Each time you start recording the counter value will clear and the count will start from 0. You can shoot always while checking the recording time
of the clip you are currently shooting.
@ @
NOTE
t If the <RESET> button is pressed while the counter value is displayed, the counter value is reset. It will start again from 0.
t The counter value is displayed by the frame unit.