- 109 -
Menu operation method
≥
The Camera Text Menu is not displayed when [PRIORITY MODE] is set to [IP(4K)] or [REC/PB(4K)].
≥
Perform the menu operations and exit from the menus using the controller which displayed the Top Menu.
If a menu operation has been performed or a menu has been exited using another controller, first display the Top
Menu and exit from it using one controller, and then display the Top Menu and exit from it using the other controller.
≥
The unit uses a different method to operate its menus from the one employed by the convertible cameras and HD
integrated cameras which have already been launched onto the market. For details, refer to the Operating
Instructions of the camera concerned.
≥
The response speed of the camera differs slightly depending on the controller used.
Camera Text Menu
operation
Remote camera controller
AW-RP50
AW-RP120
AK-HRP200
Selecting the unit to be
operated
Press one of the [CAMERA STATUS/
SELECTION] buttons.
1
Press and hold the [SELECT]
button for about 2 seconds.
≥
The camera number in the camera
number display area blinks.
2
Press the lit [UP]/[DOWN] button.
≥
Press the lit [UP]/[DOWN] button to
select the camera number.
3
Press the [SELECT] button.
≥
Control of the selected camera is
enabled.
Displaying the Top Menu
Press the [CAMERA OSD] button for
about 2 seconds.
Press and hold the [CHARA/MENU]
button for about 2 seconds.
≥
The Camera Text Menu of this unit is displayed in the IP image.
*
* The Camera Text Menu is not output from the HDMI OUT terminal/SDI OUT
terminal of this unit.
Selecting the items
Turn the [F1] dial.
Turn the [SELECT] dial.
Displaying the sub-menus Press the [F1] dial.
Press the [SELECT] dial.
Returning to the previous
menu
With the cursor at the “Return”
position, press the [F1] dial.
With the cursor at the “Return”
position, press the [SELECT] dial.
Changing the settings
1
Press the [F1] dial to start the
setting blinking.
2
Turn the [F1] dial to change the
setting.
3
Press the [F1] dial to enter the
setting (and stop the blinking).
1
Press the [SELECT] dial to start
the setting blinking.
2
Turn the [SELECT] dial to
change the setting.
3
Press the [SELECT] dial to enter
the setting (and stop the
blinking).
Exiting the menu
operations
Press the [CAMERA OSD] button for
about 2 seconds.
Press and hold the [CHARA/MENU]
button for about 2 seconds.
AG-UMR20PJ.EJ(DVQP1321ZA)_E.book 109 ページ ２０１７年５月２２日 月曜日 午後２時１１分
