– 90 –
Chapter 5 Preparation — Power supply
Power supply
A battery or an external DC power supply can be used as power supply.
Using batteries
Batteries with validated connection with the camera are as follows.
r
Anton/Bauer batteries
HYTRON50, HYTRON140
DIONIC90, DIONIC160, DIONIC HC
r
IDX batteries
ENDURA7, ENDURA10, ENDURA HL9
r
PAG batteries
PAG L96e
@
@
NOTE
t
Other batteries may be supported by changing the setting menu, but we recommend that you use batteries with connection to the camera
validated.
t
Before you use a battery, charge it with a battery charger. (For details on charging, refer to each instruction operation.)
Mounting and setting battery
Using Anton/Bauer batteries
1
Mount an Anton/Bauer battery.
Power supply output terminal for lighting
Anton/Bauer battery
Light control switch
@
@
NOTE
t
The Anton/Bauer battery holder includes both a power supply
output terminal for lighting and a light control switch, which are
convenient when installing light. Contact Anton/Bauer, Inc. for
details on lighting systems.
2
Insert the battery, and slide it in the direction of the arrow.
Release lever
@
@
NOTE
t
To remove the battery, keep the release lever of the battery
holder completely down, slide the battery in the opposite
direction of when you mounted it.
3
Set the battery type.
Set the battery type with the [BATTERY SELECT] item on the setting
menu [BATTERY SETUP] screen.
For details, refer to “Setting menu basic operations” (page 118).
Using V-mount type batteries
Mount the V-mount adaptor plate. As shown in the figure, insert and slide in the direction of the arrow.
f
When removing the plate, remove by sliding the release lever.
Release lever
