79
Menu
The underlined settings are the factory mode settings.
PLAYBACK FUNCTIONS screen
Item
Description of settings
REPEAT PLAY
This is used to set repeat playback. (Page 45)
ON:
Playback is repeated. After playing back the last clip in the playable format which
has been set in the “SYS FORMAT” item on the “RECORDING SETUP” screen, the
first clip in the playable format is played back in succession.
OFF:
Playback is not repeated. After playing back the last clip in the playable format,
playback stops.
<Note>
• Repeat playback is not performed when playing back from a text memo position.
• If a P2 card is ejected during repeat playback, playback stops when the clip on the
ejected P2 card is reached.
• If a P2 card is inserted during repeat playback, the clips on the inserted P2 card will
be played back when repeat playback is next performed.
AUDIO OUT
This is used to set the audio signals to be output from the AUDIO OUT connectors
(pin jacks), speaker and headphone jack during playback.
CH1 · CH2:
CH1 connector = CH1 signal, CH2 connector = CH2 signal,
CH1:
CH1 connector = CH1 signal, CH2 connector = CH1 signal,
CH2:
CH1 connector = CH2 signal, CH2 connector = CH2 signal,
CH3 · CH4:
CH1 connector = CH3 signal, CH2 connector = CH4 signal,
CH3:
CH1 connector = CH3 signal, CH2 connector = CH3 signal,
CH4:
CH1 connector = CH4 signal, CH2 connector = CH4 signal,
AV OUT SETUP screen
Item
Description of settings
CMPNT/SDI SEL
This is used to set the format when D connector signals and HD/SD-SDI signals are output.
(When the 59.94 Hz system format is set)
A setting other than 480i/60i or 576i/50i must be selected for the “SYS FORMAT”
item. (Page 72)
AUTO:
Operation reflects the setting selected for the SYS FORMAT item on the
RECORDING SETUP screen.
1080i, 480i
(When the 50 Hz system format is set)
AUTO:
Operation reflects the setting selected for the SYS FORMAT item on the
RECORDING SETUP screen.
1080i, 576i
SDI OUT
This is used to set the SDI output.
ON:
SDI signals are output.
OFF:
SDI signals are not output.
SDI METADATA
This is used to set whether to superimpose the meta-data when HD-SDI signals are output.
ON:
The meta-data is superimposed.
OFF:
The meta-data is not superimposed.
SDI EDH
This is used to set whether to superimpose error detection handling (EDH) when SD-
SDI signals are output.
ON:
EDH is superimposed.
OFF:
EDH is not superimposed.
SETUP
(This item is displayed
only when 59.94 Hz is
set.)
The setup level of the video signals during playback is set.
0%:
0 % is set as the output setup level.
7.5%A:
7.5 %A is set as the output setup level.
