34
Setup
Inserting/removing an SD
card
Be sure to set the mode dial to OFF before
inserting/removing an SD card.
1
Set the mode dial to OFF.
≥
Check that the status indicator has gone
off.
2
Open the card slot cover and
insert (remove) an SD card into
(from) the card slot
≥
When inserting an SD card, face the label
side
A
upwards and press it straight in as
far as it goes.
≥
When removing the SD card, press the
center of the SD card and then pull it
straight out.
3
Securely close the card slot
cover.
ª
Concerning the SD card
≥
Do not touch the terminals on the back of the
SD card.
≥
Electrical noise, static electricity or the failure of
this unit or the SD card may damage or erase
the data stored on the SD card. Save important
data recorded on this unit to a PC using the
HD Writer Ver2.5 etc. (
99) (We recommend
using HD Writer Ver2.5 to acquire data
recorded on this unit.)
≥
When using an SD card on which data has
been written many times, the remaining time
left for recording may be reduced. (
ª
Card access lamp
≥
When this unit accesses the SD card (reading,
recording, playback, erasing etc.), the access
lamp lights up.
≥
If the following operations are performed when
the access lamp is lit, then the SD card or the
recorded data may be damaged or this unit
may malfunction.
– Opening the card slot cover and removing
the SD card
– Operating the mode dial
– Removing the battery or disconnecting the
AC adaptor
If the SD card is inserted or removed while the
power is on, this unit may malfunction or the
data recorded on the SD card may be lost.
VQT1R33(E).book 34 ページ ２００８年３月６日 木曜日 午後４時３３分
