Panasonic AG-DVC200P, Operating Instructions Manual

Page: 14 / 44

14
Preparation
Setting the camera ID
The camera ID is set on the <CAMERA ID> screen. Up to 12
alphanumerics, symbols and spaces can be used.
<Note>
The camera ID does not appear while the setting menu is displayed
even when color bar signals are output.
<Note>
The camera ID input above will be recorded at the same time as the
color bar signals.
1
Proceed with the sub-menu operation
(page 30), and open the <CAMERA ID>
screen.
4
Keep turning the JOG dial button until the
character to be set appears.
6
Turn the JOG dial button to move the
arrow (cursor) to the next position (on the
right), and repeat steps 3, 4 and 5 to enter
the remaining characters.
5
Press the JOG dial button to enter the
character.
7
Press the MENU button to end the menu
operation.
# 3
< CAMERA ID >
CAMERA ID:ID
ID:
¢¢¢¢¢¢¢¢¢¢¢¢
2
Turn the JOG dial button to move the
arrow (cursor) to the ID item.
3
When the JOG dial button is pressed, the
arrow (cursor) flashes to signal that the
input mode has been established.
3
< CAMERA ID >
CAMERA ID:ID
v
#
ID:
¢¢¢¢¢¢¢¢¢¢¢¢
When the button is turned, the character display is switched in
the following sequence:
Space:
∏
7
Letters of the alphabet: A through Z
7
Numbers: 0 through 9
7
Symbols: ', >, <, /, -
The setting menu is cleared, and the unit’s current status is
displayed.
To change the
;
back to
>
, press the JOG dial button when
the
;
is above the colon (:).
Setting the date and time
1
Proceed with the sub-menu operation
(page 37) to open the <TIME/DATE> screen.
# 3
< TIME/DATE >
YEAR :01
MONTH :01
DAY :01
HOUR :00
MINUTE :00
TIME/DATE SET:READY
2
Turn the JOG dial button to select the item
to be changed, and press the JOG dial
button.
3
< TIME/DATE >
YEAR :01
MONTH :01
DAY :01
HOUR :00
#
MINUTE :00
TIME/DATE SET:READY
4
When the setting is completed, turn the
JOG dial button to select TIME/DATE SET,
and press the button.
3
< TIME/DATE >
YEAR :01
MONTH :01
DAY :01
HOUR :00
MINUTE :00
#
TIME/DATE SET:OK
3
Turn the JOG dial button to change the
setting, and then press the button to enter it.
The READY display changes from ACTIVE to OK, and the
clock function starts operating.
The setting menu is cleared, and the unit’s current status is
displayed.
5
Press the MENU button to end the menu
operation.
<Note>
≥
The seconds cannot be set. The time always starts from zero
seconds.
≥
At normal temperature with the power off, the clock will have an
accuracy of ±30 seconds/month. When accurate time is
necessary, check the time with the power on and reset to the
correct time.