Panasonic AG-CX350E, Operating Instructions Manual

Page: 86 / 199

– 86 –
Chapter 4 Operation — Menu settings
[WAVE/VECTOR] Displays the waveform and the vector.
The waveform, vector or no display toggles in order each time the USER button to which [WFM] is assigned is pressed or the
USER button icon is touched.
(Factory setting: [WAVE])
[WFM TRANSPARENCE]
Sets the transmittance of the waveform monitor.
The items that can be set are as follows.
f [0%], [25%], [50%]
(Factory setting: [25%])
[LEVEL GAUGE]
[LEVEL GAUGE]
Displays/hides the level gauge.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [ON])
[LEVEL GAUGE RESET]
Sets the horizontal and vertical reference value set by [LEVEL GAUGE SET] in the USER button to the factory setting.
The items that can be selected are as follows.
f [YES], [NO]
[RECORDING] menu
Sets the various items in the recording function.
[FORMAT MEDIA]
Formats the memory card in the specified card slot. Data deleted as a result of formatting cannot be restored. Always confirm the data before formatting.
The items that can be selected are as follows.
f [SLOT1], [SLOT2]
[CLIP NAME]
[CAM INDEX]
Sets the CAM INDEX used in the name for the MOV format file to be recorded. Set one upper case alphabetical character. This is used as a value to be
stored in the volume label of the memory card.
The items that can be set are as follows.
f [A]…[Z]
(Factory setting: [A])
[NEXT CARD COUNT]
Sets the CARD COUNT used in the name for the MOV format file to be recorded. In the following cases, the setting value in [NEXT CARD COUNT] is
stored in the volume label of the memory card together with the [CAM INDEX] setting value as CARD COUNT. Also, the setting value will increase one
after storing. ([001] returns after [999])
f When formatted the memory card
f When recorded to the memory card where CARD COUNT is not stored in the volume label
The items that can be set are as follows.
f [001]…[999]
(Factory setting: [001])
[2 SLOTS FUNC.]
Sets the recording function that uses two memory cards.
[OFF] Does not set.
[RELAY REC] Sets to the relay recording.
[SIMUL REC] Sets to the simultaneous recording.
[BACKGR REC] Sets to the background recording.
(Factory setting: [RELAY REC])
@ @
NOTE
t For the combinations and restrictions of the settings, refer to “Recording function that cannot be used simultaneously” (page 188).
[PRE REC]
Sets whether to perform pre-recording.
The pre-recording time varies depending on the setting of the [SYSTEM] menu
→ [REC FORMAT].