- 60 -
To remove the external microphone, etc., from the AUDIO INPUT1, 2 terminals
(XLR 3 pin)
≥
Set INPUT1, 2 switches to LINE or MIC if you connect equipment not compatible with
+48 V. You can damage this unit or such equipment if you leave the setting at +48V.
≥
This unit is turned off when a problem occurs with the +48 V power supply.
≥
The battery will discharge faster if you use a phantom microphone.
Adjusting the audio input level
You can set how to adjust the audio input level for each audio channel. For audio channel 1, select
[AUDIO LEVEL CH1]; for audio channel 2, select [AUDIO LEVEL CH2].
1
Select the menu.
2
(If you have set to [MANUAL])
Adjust the input level operating the AUDIO LEVEL CH1/AUDIO LEVEL CH2
knobs.
≥
Adjust confirming the audio level meter.
Remove while pushing on the PUSH
section of the AUDIO INPUT1, 2 terminals
(XLR 3 pin).
≥
Set the input signal to built-in
microphone by switching the CH1, CH2
switches to INT (L) or INT (R) after
removing the external microphone. Audio
will not be recorded when motion picture
is recorded without switching.
Selecting an adjustment method
: [AUDIO SETUP]
#
[AUDIO LEVEL CH1] or [AUDIO LEVEL CH2]
#
desired setting
[AUTO]
:
Adjusts the level automatically.
[MANUAL]
:
Adjusts the level manually.
ヱヶヴラ
A
PUSH section
MENU
CH1
CH2
AUDIO
A
AUDIO LEVEL CH1/AUDIO LEVEL CH2 knobs
B
Audio level meter
C
-12 dB
D
0 dB
R68S3_PJPB.book 60 ページ ２０１６年９月２日 金曜日 午前１０時４３分
