Panasonic AFP0HC32ET, User Manual, Page: 37 / 102

3.3 Settings of Connection Using FP0H as Originator
3-11
3.3.4 Setting IP Address of Target
Set the IP address of the target added to Scan List. The following procedure is explained on
the assumption that the EtherNet/IP setting screen has been activated.
PROCEDURE
1. Select the node name of the target from Scan List.
The "Device Setting" screen appears.
2. Set the "IP Address" of the target.
In this example, "IP address = 192.168.1.7".
3. Specify a node name as necessary.
In this example, "Node Name = FP0H(B)".
KEY POINTS
•
Unchanging the node name does not affect the cyclic communication. The
change is reflected in Scan List. It helps to distinguish the targets of the
same device.
•
When setting "Valid/Invalid Flag" to "Invalid", the reservation node setting
is enabled.