Panametrics Sentinel, User Manual, Page: 88 / 166

Chapter 3. Operation
88 Sentinel™ User’s Manual
3.12.2 Using PanaView to Clear the Totalizers (cont.)
1. Click on a totalizer to reset it (+ActMetTot in this example).
2. Right click to bring up
Properties
.
3. Click on
Properties
. The current total will be displayed (see Figure 68 below).
4. Click the
Reset
button. The counter will be reset to 0.
5. Click
OK
.
6. Repeat the procedure for each totalizer in Channel 1, Channel 2, and Average to reset all totalizers.
Figure 27: Actual Metric Total Fwd on Average
3.12.3 Returning to Operation
1. Verify that all totalizers have been cleared.
2. Power down the electronics.
3. Move the #8 DIP switch to the
OFF
(right) position.
4. Power up the electronics and verify the operations, including the display board.
5. Reapply a new lead and wire seal, if such security is needed, and reinstall the front cover.