Panametrics Sentinel, User Manual, Page: 86 / 166

Chapter 3. Operation
86 Sentinel™ User’s Manual
3.12.1 Preparing the Electronics (cont.)
5. Use a small screwdriver to move the top (#8) switch to the
ON
(left) position (see Figure 66 below).
6. If the system is not already connected to a PC or laptop computer, use the RS232 (or RS485) terminal on the rear
of the electronics package to make the connection.
7. Power up the electronics.
Figure 25: Moving DIP Switch #8 to ON
3.12.2 Using PanaView to Clear the Totalizers
Please be aware of the following:
• Only the PanaView Meter Browser window can be used to reset the totalizers (see Figure 67 on page lxxxvii ).
• Each channel has its own totalizer:
• Channel 1 (Path 1)
• Channel 2 (Path 2)
• Average (average of Paths 1 & 2)
• Totalizers are reset under the metric objects:
• +ActMetTot
• –ActMetTot
• +NrmMetTot
• –NrmMetTot
• Resetting the metric totalizers will reset the English totalizers automatically.
DIP Switch #8
ON
OFF